PrimaryUnitsMapping Parameter

Default Value: 0

Minimum Value: 0

Maximum Value: 1

Units: None

Type: int

Use the PrimaryUnitsMapping parameter to configure how the G71 (Metric) and G70 (English) G-code commands map to Primary and Secondary unit modes.

If you set this parameter to Metric, then issuing the G71 command will place the task in Primary units mode and issuing the G70 command will place the task in Secondary units mode.

If you set this parameter to English, then issuing the G70 command will place the task in Primary units mode and issuing the G71 command will place the task in Secondary units mode.

This parameter also has an effect on how the METRIC and ENGLISH keywords are interpreted when processing axis calibration files.