HarmonicCancellation0Period Parameter

Default Value: 0.0

Minimum Value: 0.0

Maximum Value: None

Units: None

Type: double

Optional Purchase Necessary: This parameter is available only if you purchased the Dynamic Controls Toolbox option.

HARDWARE: Harmonic Cancellation does not apply when used with the GI4, the GL4, the SI4, or the XL4s.

Before you use this parameter, you must enable the HarmonicCancellationSetup Parameter.

Use the HarmonicCancellation0Period parameter to configure the period of the input to the Harmonic Cancellation algorithm. When you set the HarmonicCancellation0Type Parameter parameter to Frequency, the value of this parameter is the period of the signal in seconds. When you set the HarmonicCancellation0Type Parameter parameter to Position, the value of this parameter is the period of the signal in counts.

To configure this parameter in Automation1 Studio, open the Configure Workspace. In the Axes category, select the Optimization topic and find the Harmonic Cancellation module.