Brake Power Supply Connector
This port is the power supply connection to the on-board brake control circuit. Refer to Brake Outputs for more information about the brake output interface.
Table 2-51: Brake Power Supply Connector Pinout
| Pin# | Description | In/Out/Bi |
Connector |
|---|---|---|---|
|
1 |
Brake Power Supply (+) |
Input |
|
|
2 |
Brake Power Supply (-) |
Input |
Table 2-52: Brake Power Supply Mating Connector Ratings
| Specification | Description | |
|---|---|---|
| Type | 2-Pin Terminal Block | |
| Part Numbers | Aerotech: ECK02391 | |
| Phoenix: 1827635 | ||
|
Conductor Cross Section |
One conductor, stranded with ferrule and plastic sleeve | 18...22 AWG (0.25...0.75 mm2) |
| Two conductors (same cross-section), stranded, twin ferrule with plastic sleeve | 20 AWG (0.5 mm2) | |
| Tightening Torque | 0.22...0.25 N·m | |
| Conductor Insulation Strip Length | 7 mm (0.25 in) | |
|
(1) Refer to the manufacturer website for additional information. |
||