Laser Interface Outputs
Three laser output signals are available as 5V TTL signals. These signals are active high and are driven to 5V when the laser output is turned on.
The laser outputs can be configured for different laser modes. Refer to the GalvoConfigureLaserMode() function topic in Automation1 Help for more information.
WARNING: After you install this product, you must tell the operator about all applicable safety conditions and safety information. Refer the operator to the laser manual for safety information about the laser.
Table 2-20: Laser Output Pins on the Analog I/O and Laser Interface Connector
|
Pin # |
Description |
In/Out/Bi |
|---|---|---|
| 11 | Laser Output 1 / PSO Output (TTL) | Output |
| 1 | Common | Output |
| 12 | Laser Output 2 | Output |
| 2 | Common | Output |
| 13 | Laser Output 3 | Output |
| 3 | Common | Output |
Table 2-21: Laser Output Specifications
|
Specification |
Value |
|---|---|
|
Output |
5 V, 50 mA (max) |
|
Maximum Frequency |
12.5 MHz |
|
Output Latency |
5 ns |
