GalvoScannerInterface Parameter
Default Value: 0
Minimum Value: 0
Maximum Value: 3
Units: None
Type: int
Parameter Settings and Values
This table shows the value of the configuration for the parameter setting.
Table: Parameter Settings, Configurations, and Values
| Setting | Configurations | Value |
|---|---|---|
|
Scanner Interface |
None |
0 |
|
XY2-100 |
1 |
|
|
XY2-100 (Custom Variant) |
2 | |
|
XY3-100 (20-Bit) |
3 |
HARDWARE: This parameter applies only when used with the GI4.
Use the GalvoScannerInterface parameter to specify the communication protocol of the connected scanner. You must set this parameter to the same value on all the axes of the GI4.
